Flexible Strip 7.2W/m 150 LED – all colours, 5m
£55.00
- Flexible self-adhesive LED strips
- Waterproof (to IP65)
- Contains 150 Ultra High Brightness wide angle (5050 Tri-led) LEDs per 5 Metre roll
- Wattage per meter: 7.2W maximum, 4.8W contimuous (without heatsink) at 12v
- Wattage per 5m roll: 36W maximum, 24W continuous (without heatsink) at 12v
- Voltage: 12 volts DC (should be used with a 12v voltage regulator on boats, cars etc)
- Measured Current draw at 12v: 0.4 Amps/metre; 2 Amps/roll
- 120 degree wide angle light
- Cuttable every 5cm (every 3 LEDs)
- Dimensions: 10mm wide, 2.2mm thick, 5 metres long
- Ideal for long runs of linear lighting such as under gunwale/gunnel lighting
- See LED Controllers & Drivers for suitable
*** NEW Flexible 12v LED strips ***
Waterproof to IP65
- Flexible self-adhesive LED strips
- Waterproof (to IP65)
- Contains 150 Ultra High Brightness wide angle (5050 Tri-led) LEDs per 5 Metre roll
- Lumens: 675L/m (Cool White)
- Lumens: 585L/m (Pure White)
- Lumens: 585L/m (Warm White)
- Lumens: 135L/m (Red)
- Lumens: 315L/m (Green)
- Lumens: 99L/m Blue)
- Lumens: 135L/m (Amber)
- Lumens for RGB strip: 45L/m (Red); 105L/m (Green); 45L/m Blue)
- Wattage per meter: 7.2W maximum, 4.8W contimuous (without heatsink) at 12v
- Wattage per 5m roll: 36W maximum, 24W continuous (without heatsink) at 12v
- Voltage: 12 volts DC (should be used with a 12v voltage regulator on boats, cars etc)
- Measured Current draw at 12v: 0.4 Amps/metre; 2 Amps/roll
- 120 degree wide angle light
- Cuttable every 5cm (every 3 LEDs)
- Dimensions: 10mm wide, 2.2mm thick, 5 metres long
- Ideal for long runs of linear lighting such as under gunwale/gunnel lighting
- See LED Controllers & Drivers for suitable
| Colour | Warm White, Cool White, Pure White, Red, Green, Blue, RGB, Amber |
|---|
Simon Blackburn (verified owner) –
First rate strip, easy to install and gives a nice light. I have used it for galley and navigation area task lighting, open-front locker lighting (book case and glasses cabinet) and for the inside of lockers, refrigerator and heads mood lighting . Soldering when cutting to length is required. Works wonderfully with the LED control unit which allows nice control for dimming etc. Take Richard’s advice and mount on a heat sink (aluminium extrusions are easy to source and look terrific) and always drive them through a regular – for safety. Again, Richard’s advice on safety not only assures piece of mind but makes for a tidy installation. I cannot fault this company or its products.
David carden (verified owner) –
Great product and great people to deal with . For a novice like me it was easy to fit thanks to Richards advice and guidance