Convert Low Voltage 2D Fluorescent lights in a few simple steps using our G4W-21LP LED board . Most 2D units have a 16W tube and you will get the same amount of light for just 2.7W

This is only for low voltage 12v or 24v lights found in boats or caravans, NOT suitable for mains voltage fluorescent lights!

Step 1

Typical 2d Flourescent Light

Step 2

Remove 2D tube to expose
Fluorescent driver boardt

Step 3

Use snips to cut the wires to the old fluorescent drivers

Step 4

Mark outline of LED bulb on
rear panel.

Step 5

Build up two small pillars of
hot-melt glue See note below

Step 6

Reconnect wires as shown,
black to black, red to switch etc

Step 7

wiring detail, switch wired
between the red wires

Step 8

Place LED disk over pillars and
add final blobs of glue to secure

Step 9

Finished item, same/greater
light but at 3W instead of 16W

Note: If you don’t have a hot-melt glue gun you can use double sided ‘sticky fixers’ but in either case ensure enough height to allow air to circulate beneath – this helps to keep everything cooler and extends LED life!

Feel free to share this guide

Leave a Reply

Your email address will not be published. Required fields are marked *

Annual holiday shutdown

Our annual holidays and mid-year stock take means we only have a skeleton crew operating from Monday 25th March to Friday 29th March. Normal service will resume on 02/04/2024. Orders placed during this week may be subject to delays but we will strive to get as many orders as we can out each day.